I think those might be too hard. They are Antimony/Lead with a (heavy) nickel plating. Pellets are soft lead.
I "need" a new mold. LOL I put a post down in Group Buy Discussion. I am thinking .224" finished size.
Printable View
Dverna I suspect that I agree with you.
They do have one advantage over a pellet, wind will mess with them less. Less to get aholt of.
I have not shot them at 25 or 50 yards because it would either cost me 20$ range fees (assuming I could find one that would let me shoot an airgun at that range) or it is 20 + miles one way to an "open" range with no RSO's, no rule enforcement, and no safety. Anything could happen out there.
The last option is a 40 mile drive out to the farmland I am selling via Contract for deed. I suspect those boys might look at me a mite strange. But I doubt they'd say a word.
None of which gives me any incentive to actually test those round balls. I'll let someone else lead and see what they say.
True MOA 1/2 inch at 50 yards I'd be pretty surprised. But it is possible. Not that I'd bet the farm on it. But I wouldn't bet the farm against it either. Miracles happen some days.
It was an investment I made, and something I played with because I was interested.
Doesn’t sound like a cost effective use of time for airgun pellets but... it’s your time...
If you buy a NOE pellet mould you get three different pins to form the base skirt on the pellet.
Put another way, you get three different skirt thicknesses or weights of pellet.
If you use a hot plate to get the moulds hot and keep them hot via the hot plate you will have no trouble with skirt fillout.
I shoot the lightest pellet from a pump up Benjamin .22 and the thick
est skirt from a .223 primer only cartridge case.
I need a heavier duty pellet rifle to shoot the thick skirts, although the Benjy will still shoot them but being heavier. at a lower but deeper penetrating velocity.
It's all fun and I just use wheel weights to cast them.
NOE also sells sizing dies any size .217 etc.
Casting and Handloading, it's all experimental and just depends on how much time you are willing to invest.
Those in a hurry can't afford to waste time waiting for the lead to get hot enough to cast.
Those people should go buy Walmarts pellets because next week it may be politically unwise for them to stock those lead thingies that pollute the environment.
That's about it.
Just a retired pensioner who found out just what the 'tired' in retired means.The rest you'll have to figure out on yourownselves time.
Good Luck!
Alfred,
I am retired as well. It was very interesting that the NOE mold comes with different pins.
I am going to take your advice and buy pellets. I enjoy the shooting aspect of our hobby and will leave the fun of casting to those who prefer that aspect.
I both agree and disagree. I obviously have one and use it. For my needs for the most part it is good enough.
But when you are talking about the difference between a .222 pellet and a .2235 round ball, and accuracy is only to 0.1.
Well its not what I would call precision. Better than nothing. But not a whole lot better.
Agreed, especially in a pellet gun. Considering cast boolit .25 and up .001 is quite close enough. I think for the price of a harbor freight, I paid $9.99 each on sale a few years ago. I just now saw a caliper selling for a fair price of $19.99 on the web, that's not a bad price, except they only guarantee an accuracy of 0.01, that is unacceptable. I will keep using my Harbor freight with confidence.
I'm confused. In post 27 you say accurate to .1000 (1/10) and in post 29 you indicate .001 (1/1000). Which is it?
Thanks for clearing that up.